Replace Your Old Hangers with New Double Traverse Rods

While enhancing their living rooms, people typically favor to set up curtain rods that can seamlessly match using the all round decor of the house. Presently, you'll find diverse designs of rods available. It is possible to either wish to buy easy Decorative Curtain Rods or traverse curtain rods that come with a pulley system, which tends to make it easy to open and close the drapes by just pulling the wand. Some of the hardware of those rods operates by way of a side draw whereas other individuals make use of center draw.

The layout of the drapes although employing these rods is going to be such that an S-shaped pin attaches to the pleats in your drapes using a Curtain Hook finish that may be noticed via the little hole inside the hanger. Because the hangers employed are produced of plastic, they can break or wear out easily when exposed to sun or using the passage of time. However, these hangers are not really expensive and may be simply purchased and installed in just a couple of minutes time. Once they develop of their age, you are able to replace them to initiate a suitable functioning of your rods and curtains.

This article discusses techniques by way of which you can replace your old, worn-out hangers with new ones.

Whether you happen to be making use of single or double traverse rods, it's 1st required for you personally to detach the panels in the drapes from the corner of the bracket to expose the traverse rod around the side which has the Curtain Hangers broken. By lifting the hooks, continue to get rid of the drapes from the corner of bracket.

After you might be completed with their removal, now detach the hooks in the hangers and set the drape in one side to expose the hardware, rod and ring hangers. To prevent the loss of any pins, which may well be stuck inside the seams from the pleats, fold the drapes and maintain them aside. Even so, should you believe that your curtains want some cleaning, cautiously get rid of the hooks and from the pleats.

The following step would be to unlock the rod, which might be completed by pressing down the tab around the pulley situated on the either side in the rod. This step aids you to effortlessly slide sling hanger off the rod. Now slide the hanger over the housing and through the hole provided, lift it out very carefully.

Through the open end, take away the broken plastic hangers and replace them with new ones. Now match the new hangers by way of the finish on the rod as well as the slot. Just ensure that the hanger faces inside the forward direction.

After the complete procedure is more than, reattach the drapes or curtains around the traverse rods by inserting the hook end in the s-shaped pin, which could be observed on the backside from the pleated drapes.

The same procedure could be followed with extra-long traverse rods. Even so, be carefully whilst reattaching the drapes as the s-shaped hooks includes a sharp pointed finish, which can get poked in your finger.